A below-ground tank is held up by the soil around it. The lining’s job is mainly to be watertight and to resist cracking, not to carry the full water pressure on its own. That opens the door to reinforcing the lining with natural fibres instead of steel, which cuts the cost further.
How fibre reinforcement works
Short fibres mixed into, or laid within, a cement mortar lining bridge the fine cracks that form as the mortar dries and shrinks. They hold the lining together so that small cracks stay small. The surrounding soil supports the walls, so the lining can stay thin.
The four fibres we use
Coconut coir
Coir is tough, widely available along the Konkan coast and resists rotting better than most plant fibres. Coconut coir cement tanks below ground have been built at our Karjat and Kashele resource centres, at Naresh wadi in Talasari, Badlapur, Bhopoli and Tara.
Jute
Jute is easy to buy as sacking and gives a uniform mat to embed in the mortar. See the jute fibre cement tank at Karjat Resource Centre.
Banana fibre
Banana stems are usually thrown away after harvest. Their fibre can be extracted locally and used in a banana fibre cement tank.
Flax (ambadi)
Ambadi is grown in many parts of Maharashtra and its fibre is strong. The flax (ambadi) fibre cement tank was built at Karjat and at YMC Tara.
Building one, in outline
- Dig the pit with sloping or rounded sides; avoid sharp corners where cracks start.
- Compact and smooth the soil surface so the lining has firm, even support.
- Apply a first coat of mortar, lay the fibre, and cover it completely with a second coat.
- Cure for at least two weeks, and cover the tank to cut evaporation and keep children and animals safe.
Limits to keep in mind
Plant fibres can decay if they are left exposed, so they must be fully buried in mortar. Fibre tanks suit below-ground use, where the soil carries the load; for tanks above ground we use ferro cement. Every type can be seen side by side at the Karjat Rain Water Resource Centre.




